Datalogic QuickScan QBT2400 User Manual

Product Reference Guide 9
Chapter 2
Setup
Unpacking
Check carefully to ensure the reader and any accessories ordered are present and undamaged.
If any damage occurred during shipment, contact Datalogic Technical Support. Information is
shown on page 2.
KEEP THE PACKAGING. Should the unit ever require se
rvice, it should be returned in its original
shipping container.
Setting Up the Reader
Depending on whether you are using a Corded or Wireless version of the QuickScan, follow the
steps provided in this section to connect and get your reader up and communicating with its
host.
1. Begin by Installing the Interface Cable (Corded) or Connecting the Base Station (BT and
Star).
2. Go to Interface Selection and set the desired interface.
3. Configure Interface Settings (only if not using factory settings for that interface).
4. Go to Configuring Other Features (if modifications are needed from factory settings).

Datalogic QuickScan QBT2400 Specifications

General

Connectivity	Bluetooth
Battery Type	Lithium-Ion
Battery Capacity	1400 mAh
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Interfaces Supported	USB, RS-232, Keyboard Wedge
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Radio Range (Open Air)	100 m
Type	Handheld
Scan Rate	60 frames per second
Resolution	0.1 mm
Humidity	5 to 95% non-condensing
Light Source	Red LED
Supported Barcodes	1D / 2D and postal codes