Datalogic QuickScan QBT2400 User Manual

Enter/Exit Programming Mode Scanning Features
84 QuickScan™ I QD24XX/QBT24XX/QM24XX
Partial Label Reading Control
Enable/Disable to ignore partial labels to be read within the boundary of the field of view.
IPPL00
Partial Label Reading Control = Disable
IPPL01
Partial Label Reading Control = Enable
Decode Negative Image
Enable/Disable the ability to decode a negative image for all symbologies. When this feature is
enabled, you will be unable to read normally-printed labels or programming labels in this man-
ual. Scan the “Disable” bar code below to return the scanner to its default for this feature. To set
decoding for only 2D codes, g
o to "2D Normal/Inverse Symbol Control" on page 181. For
addi-
tional options, see the Aladdin configuration application.
CAUTION
$P,CIPVR00,P(CR)
Decode Negative Image = Disable
DEFAULT
$P,CIPVR01,P(CR)
Decode Negative Image = Enable
When this feature is enabled, you will be unable to read other programming labels in this
manual.
Unlike some programming features and options, Decode Negative Image selections require
that you sc
an only one programming bar code label. DO NOT scan an ENTER/EXIT bar code
prior to scanning a Decode Negative Image bar code.

Datalogic QuickScan QBT2400 Specifications

General

Connectivity	Bluetooth
Battery Type	Lithium-Ion
Battery Capacity	1400 mAh
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Interfaces Supported	USB, RS-232, Keyboard Wedge
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Radio Range (Open Air)	100 m
Type	Handheld
Scan Rate	60 frames per second
Resolution	0.1 mm
Humidity	5 to 95% non-condensing
Light Source	Red LED
Supported Barcodes	1D / 2D and postal codes