Datalogic QuickScan QBT2400 User Manual

WIRELESS FEATURES Enter/Exit Programming Mode
Product Reference Guide 215
Docking Beep
Enables/disables a beep indication when the handheld is placed in the Base Station.
$CBTCB00(CR)
Docking Beep = Disable
$CBTCB01(CR)
Docking Beep = Enable
DEFAULT
Leash Alarm
This setting specifies the number of seconds to sound the Leash Mode beeps (three per second)
when the handheld goes out of range. This is especially useful in instances where the reader
might inadvertently have been placed in a bag or cart.
For this mode to be effective, the reader must be linked to
the Base Station. If the reader is
asleep or disconnected from the Base Station, there is no way for it to know where it is relative
to the Base Station because communication is not active between the devices.
DEFAULT
$CBTLB00(CR)
Leash Alarm = Disabled
$CBTLB01(CR)
Leash Alarm = 1 Second
$CBTLB02(CR)
Leash Alarm = 2 Seconds

Datalogic QuickScan QBT2400 Specifications

General

Connectivity	Bluetooth
Battery Type	Lithium-Ion
Battery Capacity	1400 mAh
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Interfaces Supported	USB, RS-232, Keyboard Wedge
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Radio Range (Open Air)	100 m
Type	Handheld
Scan Rate	60 frames per second
Resolution	0.1 mm
Humidity	5 to 95% non-condensing
Light Source	Red LED
Supported Barcodes	1D / 2D and postal codes