Datalogic QuickScan QBT2400 User Manual

Product Reference Guide 275
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of the table below.
Page references are also provided for feature descriptions and programming
bar codes for each
parameter. A column has also been prov
ided for recording of your preferred default settings for
these same configurable features.
Table 50. Standard Defaults
Parameter Default Your Setting
Page
Numbe
r
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey 25
USB Suspend Mode
Disable 25
RS-232 ONLY
Baud Rate
9600 28
Data Bits
8 Data Bits 29
Stop Bits
1 Stop Bit 29
Parity
None 30
Handshaking Control
RTS 31
RS-232/USB-COM
Intercharacter Delay
No Delay 33
Beep On ASCII BEL
Disable 33
Beep On Not on File
Enable 34
ACK NAK Options
Disable 34
ACK Character
‘ACK’ 35
NAK Character
‘NAK’ 35
ACK NAK Timeout Value
200 ms 36
ACK NAK Retry Count
3 Retries 36
ACK NAK Error Handling
Ignore Errors Detected 37
Indicate Transmission Failure
Enable 37

Datalogic QuickScan QBT2400 Specifications

General

Connectivity	Bluetooth
Battery Type	Lithium-Ion
Battery Capacity	1400 mAh
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Interfaces Supported	USB, RS-232, Keyboard Wedge
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Radio Range (Open Air)	100 m
Type	Handheld
Scan Rate	60 frames per second
Resolution	0.1 mm
Humidity	5 to 95% non-condensing
Light Source	Red LED
Supported Barcodes	1D / 2D and postal codes