Datalogic QuickScan QBT2400 User Manual

Enter/Exit Programming Mode
58 QuickScan™ I QD24XX/QBT24XX/QM24XX
Label ID
A Label ID is a customizable code of up to three ASCII characters (convert to Hex using the
ASCII Chart on the inside back cover of this manual), used to identify a bar code symbology
type. It can be appended previous to or following the transmitted bar code data depending
upon how this option is enabled. This feature provides options for configuring custom Label
IDs or individually per symbology (see "Individually Set Label ID" on page 59). If you wish to
program the reader to always include an industry standa
rd
label identifier for ALL symbology
types, see the previous feature "Global AIM ID" on page 55.
See La
bel ID, starting on page 247 of “References” for more information on setting this feature.
Label ID: Pre-Loaded Sets
The reader supports two pre-loaded sets of Label IDs. See Label ID: Pre-loaded Sets, starting on
page 247 for details on the USA set and EU set.
CAUTION
$AE(CR)
Label ID Pre-loaded Set = USA Set
$Ae(CR)
Label ID Pre-loaded Set = EU Set
DEFAULT
When changing from one Label ID set to another, all other reader configuration set-
tings, including the host interface type, will be erased an
d set to the standard factory
defaults. Any custom configuration or custom defaults will be lost.

Datalogic QuickScan QBT2400 Specifications

General

Connectivity	Bluetooth
Battery Type	Lithium-Ion
Battery Capacity	1400 mAh
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Interfaces Supported	USB, RS-232, Keyboard Wedge
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Radio Range (Open Air)	100 m
Type	Handheld
Scan Rate	60 frames per second
Resolution	0.1 mm
Humidity	5 to 95% non-condensing
Light Source	Red LED
Supported Barcodes	1D / 2D and postal codes