Datalogic QuickScan QBT2400 User Manual

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 77
Stand Operation
Specifies the behavior of the reader when stationary in a stand. There are two conditions which
cause the reader to switch to Stand Mode:
1. The reader is manually configured to switch to Stand Mode or when inserted into the spe-
cial Stand support which automatica
lly enables the Stand Mode.
2. The reader is placed into the cradle of the base station (cordless models only).
Below are further options concerning Stand Operation.
Ignore Autorecognition. Disables mode switching when the reader is placed in a stand.
Change to Stand Mode. Automatically switches the reader to Stand Mode when the reader is
placed in the stand.
Change to Flashing. Automatically switches the reader to Flash Mode when the reader is placed in
the stand.
Change to Always On. Automatically switches the reader to Always On mode when the reader is
placed in the stand
.
$CSMSD00(CR)
Do Not Change Mode
$CSMSD01(CR)
Change to Stand Mode
DEFAULT
$CSMSD02(CR)
Change to Always On
$CSMSD03(CR)
Change to Flashing

Datalogic QuickScan QBT2400 Specifications

General

Connectivity	Bluetooth
Battery Type	Lithium-Ion
Battery Capacity	1400 mAh
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Interfaces Supported	USB, RS-232, Keyboard Wedge
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Radio Range (Open Air)	100 m
Type	Handheld
Scan Rate	60 frames per second
Resolution	0.1 mm
Humidity	5 to 95% non-condensing
Light Source	Red LED
Supported Barcodes	1D / 2D and postal codes