Datalogic QuickScan QBT2400

Enter/Exit Programming Mode Wireless Beeper Features
212 QuickScan™ I QD24XX/QBT24XX/QM24XX
WIRELESS BEEPER FEATURES
Several options are available to configure beeper behavior for RF operation.
Good Transmission Beep
Enables/disables the Good Transmission Beep indication. When enabled, a beep occurs when a
Label is correctly transmitted to the base.
$CBTAB00(CR)
Good Transmission Beep = Disable
$CBTAB01(CR)
Good Transmission Beep = Enable
DEFAULT
Beep Frequency
Adjusts radio-specific beep indications to sound at a low, medium or high frequency, selectable
from the list below (controls the beeper’s pitch/tone).
DEFAULT
$CBTBF00(CR)
Beep Frequency = Low
$CBTBF01(CR)
Beep Frequency = Medium
$CBTBF02(CR)
Beep Frequency = High