Datalogic TC1200 - DEFAULT PARAMETERS TABLE; Global Interface and RS232 Defaults; RS232;USB-COM and USB-KBD Defaults

TC1200 REFERENCE MANUAL
138
A
A DEFAULT PARAMETERS TABLE
Parameter Default Your Setting Page
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore Obey
RS232 ONLY
Baud Rate 9600
Data Bits 8 Data Bits
Stop Bits 1 Stop Bit
Parity None
RS232/USB-COM
Intercharacter Delay No Delay
Disable Character ‘D’
Enable Character ‘E’
ACK NAK Options Disable
ACK Character ‘ACK’
NAK Character ‘NAK’
ACK NAK Timeout Value 600 ms
ACK NAK Retry Count 3 Retries
ACK NAK Error Handling Ignore Errors
Detected
USB-KBD
Keyboard Country Mode US
Keyboard Intercode Delay No Delay
Send Control Characters CTRL+KEY
USB Keyboard Speed 1 ms
READING PARAMETERS
Illumination Mode Triggered
Operating Modes On Line
Phase Off Event Trigger Stop
Automatic Threshold
Timeout
Serial Start STX
Serial Stop ETX
LED Indication On Decode
Label Programming Mode Enabled
DATA FORMAT
Data Transmission On Decode
Code Verifier Mode Disabled
Match String
Wrong Code String
Case Conversion Disabled
Global Prefix (Header) CR
Global Suffix (Terminator)
No Read String CAN
Transmit AIM IDs Disabled
Transmit Custom Label IDs Disabled
Custom Label Identifiers See table on page
126