Table 19: Reference values for Register file: 0x1E – Transmit Power Control, for Smart Transmit Power
Control
Example Register file: 0x1E –
Transmit Power Control values
for 16 MHz, with DIS_STXP = 0
Example Register file: 0x1E –
Transmit Power Control values
for 64 MHz, with DIS_STXP = 0
Table 20: Reference values Register file: 0x1E – Transmit Power Control for Manual Transmit Power
Control (Smart Transmit Power Control disabled)
Note: High and low octets of the 32-bit values in Table 20 are not relevant when smart TX
power is disabled.
7.2.32 Register file: 0x1F – Channel Control
Register map register file 0x1F is the channel control register. This is used to select transmit and receive
channels, and configure preamble codes and some related parameters.
The fields of the Channel Control Register are defined as follows:
REG:1F:00 – CHAN_CTRL – Channel Control Register
Example Register file: 0x1E –
Transmit Power Control values
for 16 MHz, with DIS_STXP = 1
Example Register file: 0x1E –
Transmit Power Control values
for 64 MHz, with DIS_STXP = 1
To Next Page
Loading...