7.2.41.3 Sub-Register 0x28:0B– RF_RXCTRLH
Analog RX Control Register
Register file: 0x28 – Analog RF configuration block, sub-register 0x0B is an 8-bitcontrol register for the
receiver. The value here needs to be set depending on the RX channel selected by the RX_CHAN
configuration in Register file: 0x1F – Channel Control. The values required are given in Table 37. Please take
care not to write other values to this register as doing so may cause the DW1000 to malfunction.
Table 37: Sub-Register 0x28:0B– RF_RXCTRLH values
8-bit value to program to
Sub-Register 0x28:0B–
RF_RXCTRLH
7.2.41.4 Sub-Register 0x28:0C– RF_TXCTRL
Analog TX Control Register
Register file: 0x28 – Analog RF configuration block, sub-register 0x0C is a 24-bit control register for the
transmitter. The value here needs to be set depending on the TX channel selected by the TX_CHAN
configuration in Register file: 0x1F – Channel Control. The values required are given in Table 38. Please take
care not to write other values to this register as doing so may cause the DW1000 to malfunction.
Table 38: Sub-Register 0x28:0C– RF_TXCTRL values
24-bit value to program to
Sub-Register 0x28:0C– RF_TXCTRL
To Next Page
Loading...