decaWave DW1000 - Trim

DW1000 User Manual
© Decawave Ltd 2017
Version 2.12
Page 238 of 242
Page
Change Description
All
Update of version number to v2.06
All
Various typographical changes
17
Inclusion of CPLOCK bit
23
Section2.5.5.9 - modification to FS_PLLTUNE value
46
Section 4.7.1 & 4.7.2 – modification to 16 MHz PRF calculation fixed value
73
Section 7.2.10 Correction to register default value
104 – 107
Modification of text re smart Tx Power in 7.2.31
108
Section 7.2.32 Correction to register type
148
7.2.43.5 Correction to reference in register description
189
Correction to register write value in step 8 of the crystal trim procedure
221
Addition of v2.06 to table 64
223
Inclusion of this table
Revision v2.07
Page
Change Description
All
Update of version number to v2.07
All
Various typographical changes and formatting corrections
62
TX_BUFFER register type corrected to write-only.
62
RX_BUFFER register type corrected to write-only.
76
TX_BUFFER register type changed to write-only
92 - 93
RXPACC field of RX_FINFO updated to describe adjustments that can be made to the count to
calculate more accurate receive signal power as used in calculations in section 4.7.
96
RX_BUFFER register type changed to read-only.
111
DWSFD field of CHAN_CTRL register description updated to specify Decawave-defined SFD
sequences
137
RXPACC_NOSAT added to address 0x27, subaddress 0x2C
141
Subregister 0x27:2C, RXPACC_NOSAT added
173
EVC_CTRL register description corrected to describe write-to-enable behaviour.
197
Addition of clarification text to Section 9.3 re use of different preamble codes to allow multiple
communications on the same physical channel
224
Addition of v2.07 to table 65 / Addition of Reference [2]
226
Inclusion of this table
Revision v2.08
Page
Change Description