ADVANCE FD Manual 6 Return to top
2.1. Before handling <for installation personnel>
Danger
Do not install the product in wet places. It may result in a fire caused by an electrical
short circuit.
Keep the wiring away from locations which affect steering, safety and brake systems.
Interfering with normal operation of the vehicle can result in an accident or fire.
Ensure that the vehicle will remain stationary and turn the power off before installing
this product. Failure to do so could result in a fire, and could make the vehicle move during
installation.
Remove the key from the ignition and disconnect the negative (-) battery terminal prior
to installation of this product. Failure to do so could result in a fire caused by an electrical
short circuit.
Take care not to install this product in a way that interferes with safety equipment such as
seat belts and air bag systems or vehicle operation equipment such as engine controls,
steering wheel and brake systems. Interference with normal operation of the vehicle can
result in an accident or fire.
Solder or use a solderless connector for wiring connections and make sure connections
are insulated. In areas where there could be tension or sudden impacts on the wiring,
safeguard the wiring with corrugated tubing or other shock absorbent material. Accidental
shorts can cause fires.
While wiring power supply wire, to avoid the risk of electrical shock or fire, be sure to
confirm that there is no disconnection or breakage of wire. Poor connection can result in
short-circuit, electrical shock, fire, or other hazards.
The ignition-switched +12V (IGN) line must be connected to the vehicle's ignition-
switched wire with a fuse of 30A or less. High-capacity fuse (more than 30A) will not
blowout even with an abnormal current flow and may cause fire.
Discontinue use of this product if a blowout of the fuse has occurred. Continued use while
the condition exists could result in an accident, fire, or damage to the vehicle.
Use the tube fuse of regulated capacity when the fuse of the power source wire is
changed. Using a fuse that exceeds regulated capacity may cause fire.
Discontinue use of this product if the product doesn't operate or operates improperly.
Continued use while the condition exists could result in an accident or damage.
To Next Page
Loading...
