Defi ADVANCE FD - Factory Default Warning Values

ADVANCE FD Manual 70 Return to top
9.8. Warning setup mode
Warning values can be set as desired.
There is no warning function for vehicle speed or voltage.
⇒9.7.2.2 Warning display
■Factory default settings of warning values
Minimum Maximum
100 kPa -100 300
14.5 PSI -14.5 45
Tachometer 7000 RPM 300 11000
Set value
and above
ON
120 kPa 0 1000
17.5 PSI 0 145
150 kPa 0 600
21.8 PSI 0 87
125 ℃ 0 150
257 °F 32 302
105 ℃ 0 150
221 °F 32 302
850 ℃ 0 1100
1562 °F 32 2012
Setting range
Warning
condition
Warning
output
Set value
and above
ON
Default
setting
Gauge
Unit
Turbo/
In-mani press
Oil press
Fuel press
Oil temp
Water temp
Exhaust temp
ON
ON
ON
ON
ON
Set value
and above
Set value
and above
Set value
and below
Set value
and below
Set value
and above
If ADVANCE Control Unit is already installed, the warning values which have already set are
valid.
Depending on the type and condition of the vehicle, damage may occur to the vehicle
even if the warnings are below the initial values (in cases of oil pressure and fuel pressure,
above the initial values), so consult your store and set values at the time of installation.