ADVANCE FD Manual 61 Return to top
9.7.2.5. Special mode
If the special display is set to [ON] in the system setup mode and the vehicle speed of 0
km/h (0 MPH) continues for more than 10 seconds, the special mode will be shown. During
the special mode, the odometer, trip meter, and idling time are displayed.
Idling time is not counted while the engine is stopped.
In the following cases, the special mode is terminated and the display returns to the gauge
mode.
・When a speed pulse is input
・When 【F1 button】 or 【F2 button】 is pressed
・When the mode is changed by unit operation
Special mode will not be shown in the following cases, even if the special display is set to
[ON].
・During warm-up
・When a warning occurs
・When any of the sensors is open or short-circuited
If 【F1 button】 or 【F2 button】 is pressed during the special mode, or if the mode is
changed by unit operation, the special mode display will be terminated.
If there is no vehicle speed input, the idling time will continue to be counted, and after 10
seconds, the accumulated time will be displayed when the special mode is displayed.