ADVANCE FD Manual 8 Return to top
Do not place wires near the engine, exhaust pipe or turbine. It may result in damage or
fusion of wires.
Do not expose this product to moisture, dust or direct sunlight, or place product directly
in front of heat vents.
Do not pull the wires out of connectors forcefully. The connectors may be broken and
the wires may be cut. When pulling out the wires, press the lock firmly and unclip the
locks of connectors.
Do not install this product or gauges into the passenger side or center of the dashboard.
It doesn't meet vehicle safety standards.
Do not attach wires on the body of the vehicle or engine parts as this may result in
damage to the product
This product is designed for use on 12V vehicles. Do not install this product on vehicles
with 24V systems.
Insulate any unused wires. If any wires or connectors loosen during installation, please
make sure they are correctly reattached.
Install wires away from ignition and also radio signal frequency interference as this could
cause the gauges to malfunction. Install wires away from ignition and also radio signal
frequency interference as this could cause the gauges to malfunction.
Please set it up so that the equipment, such as the wireless machines and cellular phones
that emit electric waves, does not touch this product. It may result in incorrect operation.
Make sure the waterproof processing is done when diverging wires in the engine
compartment.
When installing the sensor, do not bend the wire near the sensor body.
Wear gloves to avoid burns when soldering and cuts when installing wires, sharp edges
of parts.
Install sensors away from hot or wet places.
To Next Page
Loading...
Need help?
General
