119
Check the documentation that accompanied the drive to verify that the drive is configured for
your computer. If you are installing an IDE drive, configure the drive for the cable select setting.
2
If you are installing a new drive:
a
Press the two snaps on the top of the drive-panel insert and rotate the insert toward the front
of the computer.
b
Remove the three shoulder screws from the drive-panel insert.
3
If you are replacing an existing drive:
a
Press the two snaps on the top of the drive-panel insert and rotate the insert toward the front
of the computer.
b
Remove the three shoulder screws from the existing drive.
c
Insert the three shoulder screws into the sides of the new drive and tighten them.
4
Connect the power and CD/DVD drive cables to the drive.
5
Align the shoulder screws with the screw guides, and slide the drive into the bay until it clicks
into place.
To Next Page
Loading...
