186
www.dell.com | support.dell.com
NOTICE: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to
cables and the cable connectors.
5
Pull up the cable release tab to unlock it and disconnect the floppy-drive cable from the back of
the floppy drive.
6
Pull up the cable release tab to unlock it and disconnect the floppy-drive cable from the system
board.
7
Pull up on the drive release latch and slide the floppy drive towards the back of the computer.
Then lift up to remove the drive from the computer.
Installing a Floppy Drive
NOTE: In the event the replacement or new floppy drive does not have the shoulder screws, use the
screws located within the drive-panel insert.
1 cable release tab
2 data-cable edge connector
1
2
To Next Page
Loading...
