70
www.dell.com | support.dell.com
12
Replace the computer cover.
13
Connect any cables that should be attached to the card.
NOTE:
See the documentation for the card for information about the card’s cable connections.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it
into the computer.
14
If you installed a sound card:
a
Enter system setup, select
Audio Controller
, and change the setting to
Off
.
b
Connect external audio devices to the sound card’s connectors. Do not connect external
audio devices to the microphone, speaker/headphone, or line-in connectors on the back
panel of the computer.
15
If you installed an network adapter card and want to turn off the integrated network adapter:
a
Enter system setup, select
Network Controller
, and change the setting to
Off
.
b
Connect the network cable to the network adapter card’s connectors. Do not connect the
network cable to the integrated network connector on the back panel of the computer.
16
Install any drivers required for the card as described in the card documentation.
Removing a PCI Card
1
Follow the procedures in "Before You Begin."
2
Gently push the release tab on the card retention latch from the inside to pivot the latch open. The
latch will remain in the open position.
To Next Page
Loading...
