24 Chassis Intrusion Switch
www.dell.com | support.dell.com
Ultra Small Form Factor Computer
Replacing the Chassis Intrusion Switch
1
Gently slide the chassis intrusion switch into its slot and reconnect the cable to the system board.
2
Replace the computer cover.
3
Attach the computer stand, if it is used.
Resetting the Chassis Intrusion Detector
1
Turn on (or restart) your computer.
2
When the blue DELL™ logo appears, press <F2> immediately.
If you wait too long and the operating system logo appears, continue to wait until you see the
Microsoft
®
Windows
®
desktop. Then shut down your computer and try again.
3
Select the
Chassis Intrusion
option and then press the left- or right-arrow key to select
Reset
.
Change the setting to
On
,
On-Silent
, or
Disabled
.
NOTE: The default setting is On-Silent.
4
Press <Alt><b> to restart the computer and implement your changes.
To Next Page
Loading...
