121
NOTE: Since the following steps do not require the complete removal of the CD/DVD drive, it is not
necessary to disconnect the cables connecting the CD/DVD drive.
2
Remove the CD/DVD drive and carefully set it aside.
NOTICE: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to
cables and the cable connectors.
3
Pull up on the drive release latch and slide the floppy drive towards the back of the computer.
Then, lift up to remove the drive from the computer.
4
Disconnect the power and floppy-drive cables from the back of the floppy drive.
Installing a Floppy Drive
1
If you are installing a new drive:
a
Use a small flat-edge screw driver on the back side of the drive-panel insert to gently pop off
the insert.
b
Remove the four shoulder screws from the drive-panel insert.
2
If you are replacing an existing drive:
Remove the four shoulder screws from the existing drive.
1 drive release latch
2 floppy drive
1 2
To Next Page
Loading...
