80
www.dell.com | support.dell.com
5
Before you replace and lower the card retention mechanism, ensure that:
• The tops of all adapters and filler brackets are flush with the alignment bar.
• The notch in the top of the adapter or filler bracket fits around the alignment guide.
6
Gently press down on the card retention mechanism to secure the adapter bracket in place.
7
Close the card retention latch and gently press until it clicks into place.
NOTICE: Do not route cables over or behind any installed cards. Cables routed over the cards can
prevent the computer cover from closing properly or cause damage to the equipment.
8
Connect the adapter cable to the serial port adapter connector (SER2) on the system board.
9
Connect any cables that should be attached to the serial port adapter.
NOTE: See the documentation for the serial port adapter for information about the cable connections.
10
Replace the computer cover.
Removing a Serial Port Adapter
1
Follow the procedures in "Before You Begin."
1
fully seated card
2
not fully seated card
3
bracket within slot
4
bracket caught outside of slot
1
2
3
4
To Next Page
Loading...
