134
www.dell.com | support.dell.com
a
Enter system setup, select
Network Controller
and change the setting to
Off
.
b
Connect the network cable to the network adapter card’s connectors. Do not connect the
network cable to the integrated network connector on the back panel of the computer.
15
Install any drivers required for the card as described in the card documentation.
Removing a PCI Card From the Riser-Card Cage
1
Follow the procedures in "Before You Begin."
2
Remove the riser-card cage:
a
Check any cables connected to cards through the back-panel openings. Disconnect any
cables that will not reach the riser-card cage once they are removed from the computer.
b
Gently pull on the handle and lift the riser-card cage up and away from the computer.
3
Press in on the tab to raise the card retention latch.
4
If necessary, disconnect any cables connected to the card.
5
Grasp the card by its top corners, and ease it out of its connector.
6
If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket, contact Dell.
1
riser-card cage
2
handle
1
2
To Next Page
Loading...
