140
www.dell.com | support.dell.com
6
Connect the adapter cable to the serial port adapter connector (SER2) on the system board.
7
Connect any cables that should be attached to the serial port adapter.
NOTE:
See the documentation for the serial port adapter for information about the cable
connections.
8
Replace the computer cover.
Removing a Serial Port Adapter
1
Follow the procedures in "Before You Begin."
2
Gently push the release tab on the adapter retention latch.
3
Disconnect the cable that connects the adapter to the system board.
4
Grasp the serial-port adapter bracket by its top corners, and ease it out of its connector.
5
Replace the computer cover.
1
adapter retention latch
2
release tab
3
serial-port adapter bracket
4
serial port adapter connector
5
serial port adapter system
board connector (SER2)
2
4
5
3
1
To Next Page
Loading...
