Chassis Intrusion Switch 21
Chassis Intrusion Switch
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
Removing the Chassis Intrusion Switch
1
Follow the procedures in "Before You Begin."
2
Disconnect the chassis intrusion switch cable from the system board.
Note the routing of the chassis intrusion cable as you remove it from the chassis. Chassis hooks
may hold the cable in place inside the chassis.
3
Using a flat blade screwdriver, gently slide the chassis intrusion switch out of its slot, and
remove the switch and its attached cable from the computer.
Mini Tower Computer
To Next Page
Loading...
