49
5
Press in on the blue release tabs on each side of the drive and slide the drive up and out of the
computer.
Installing a Hard Drive
1
Unpack the replacement hard drive, and prepare it for installation.
2
Check the documentation for the drive to verify that it is configured for your computer.
NOTE:
If your replacement hard drive does not have the plastic hard-drive bracket attached,
remove the bracket from the existing drive by unsnapping it from the drive. Snap the bracket
onto the new drive.
1 hard-drive cable
2 hard-drive cable on system board
3 power cable
1 hard drive
2 release tabs (2)
2
1
To Next Page
Loading...
