177
Connecting and Disconnecting Drive Cables
When connecting and disconnecting a serial ATA data cable, hold the cable by the black connector at
each end.
Serial ATA interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one
connector matches a tab or a filled-in hole on the other connector.
Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before removing the computer cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a
surface, such as a foam pad, that will sufficiently cushion it.
1
If you are replacing a hard drive that contains data you want to keep, back up your files before
you begin this procedure.
2
Check the documentation for the drive to verify that it is configured for your computer.
Removing a Hard Drive
1
Follow the procedures in "Before You Begin."
2
Remove the computer cover.
3
Lay the computer on its side so that the system board is on the bottom of the inside of the
computer.
4
Press in on the two blue release tabs on each side of the drive and slide the drive up and out of the
computer.
1 interface cable connector
2 interface connector
Serial ATA Connector
1
2
To Next Page
Loading...
