129
7
Gently press down on the card retention latch to secure the card.
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent
the computer cover from closing properly or cause damage to the equipment.
8
Connect any cables that should be attached to the card.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it
into the computer.
9
If you installed a sound card:
a
Enter system setup, select
Audio Controller
, and change the setting to
Off
.
b
Connect external audio devices to the sound card’s connectors. Do not connect external
audio devices to the microphone, speaker/headphone, or line-in connectors on the back or
front panel.
10
If you installed an network adapter card and want to turn off the integrated network adapter:
a
Enter system setup, select
Network Controller
, and change the setting to
Off
.
b
Connect the network cable to the network adapter card’s connectors. Do not connect the
network cable to the integrated network connector on the back panel.
1
fully seated card
2
not fully seated card
3
bracket within slot
4
bracket caught outside of slot
1
2
3
4
To Next Page
Loading...
