143
3
Press the tab to raise the riser-card retention latch.
4
Disconnect the cable that attaches the adapter to the system board connector (SER2).
5
Grasp the serial port adapter by its corners, and ease it out of its slot.
6
If you are removing the adapter permanently, install a filler bracket in the empty card-slot
opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC
certification of the computer. The brackets also keep dust and dirt out of your computer.
7
Lower the riser-card retention latch and press it into place.
8
Replace the riser-card cage:
a
Align the tabs in the side of the riser-card cage with the slots on the side of the computer, and
slide the riser-card cage down into place.
b
Ensure that the riser cards are fully seated in the connectors on the system board.
9
Replace the computer cover.
10
Uninstall the adapter’s driver. See the documentation that came with the adapter for instructions.
1
riser-card cage
2
handle
3
riser cards (2)
1
2
3
To Next Page
Loading...
