72
www.dell.com | support.dell.com
7
Before you replace and lower the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
8
Gently press down on the card retention mechanism to secure the adapter bracket in place.
9
Close the card retention latch by snapping it into place.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it
into the computer.
10
Replace the computer cover.
11
Uninstall the card’s driver. See the documentation that came with the card for instructions.
12
If you removed a sound card:
a
Enter system setup, select
Audio Controller
, and change the setting to
On
.
b
Connect external audio devices to the audio connectors on the back panel of the computer.
13
If you removed an network-adapter card connector:
a
Enter system setup, select
Network Controller
, and change the setting to
On
.
1
fully seated card
2
not fully seated card
3
bracket within slot
4
bracket caught outside of slot
1
2
3
4
To Next Page
Loading...
