76
www.dell.com | support.dell.com
9
Before you replace and lower the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
10
Gently press down on the card retention mechanism to secure the adapter bracket in place.
11
Close the card retention latch and gently press until it clicks into place.
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent
the computer cover from closing properly or cause damage to the equipment.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it
into the computer.
12
Connect any cables that should be attached to the card.
See the documentation for the card for information about the card’s cable connections.
13
Replace the computer cover.
14
If you installed a sound card:
a
Enter system setup, select
Audio Controller
, and change the setting to
Off
.
1
fully seated card
2
not fully seated card
3
bracket within slot
4
bracket caught outside of slot
1
2
3
4
To Next Page
Loading...
