140 Using iDRAC6 With Microsoft Active Directory
racadm config -g cfgLanNetworking -o cfgDNSServer1
<primary DNS IP address>
racadm config -g cfgLanNetworking -o cfgDNSServer2
<secondary DNS IP address>
4
If you want to configure a list of user domains so that you only need to
enter the user name during log in to iDRAC6 Web interface, enter the
following command:
racadm config -g cfgUserDomain -o
cfgUserDomainName <fully qualified domain name or
IP Address of the domain controller> -i <index>
You can configure up to 40 user domains with index numbers between
1 and 40.
See "Using Active Directory to Log In to iDRAC6" for details about user
domains.
5
Press
Enter
to complete the Active Directory configuration with
Extended Schema.
Standard Schema Active Directory Overview
As shown in Figure 6-3, using standard schema for Active Directory
integration requires configuration on both Active Directory and iDRAC6.
To Next Page
Loading...
