380 RACADM Subcommand Overview
Description
Traces a route using IPv6 to a destination on the network.
Supported Interfaces
• Remote RACADM
• telnet/ssh RACADM
remoteimage
NOTE: To use this command, you must have Administrator permission.
Table A-52 describes the remoteimage subcommand.
Synopsis
racadm remoteimage <options>
Options are:
–m server–x ; available only from CMC
–a ; all iDRAC6s ; available only from CMC
–c ; connect image
–d ; disconnect image
–e : deploy; available only from CMC
–u <username>; username to access the network share
–p <password>; password to access the network share
–l <image_location>; image location on the network share; use double
quotes around the location
–s; display current status; –a is assumed if not specified
Table A-52. remoteimage
Subcommand Definition
remoteimage Connects, disconnects, or deploys a media file on a
remote server.
To Next Page
Loading...
