RACADM Subcommand Overview 375
Synopsis
racadm coredumpdelete
Description
The coredumpdelete subcommand can be used to clear any currently
resident coredump data stored in iDRAC6.
NOTE: If a coredumpdelete command is issued and a coredump is not
currently stored in iDRAC6, the command will display a success message.
This behavior is expected.
See the coredump subcommand for more information on viewing
a coredump.
Supported Interfaces
•Local RACADM
• Remote RACADM
• telnet/ssh RACADM
ifconfig
NOTE: To use this command, you must have Execute Diagnostic Commands or
Configure iDRAC6 permission.
Table A-45 describes the ifconfig subcommand.
Synopsis
racadm ifconfig
coredumpdelete Deletes the core dump stored in iDRAC6.
Table A-45. ifconfig
Subcommand Definition
ifconfig Displays the contents of the network interface table.
Table A-44. coredumpdelete
To Next Page
Loading...
