Dell IDRAC6 - ping

376 RACADM Subcommand Overview
Supported Interfaces
• Remote RACADM
• telnet/ssh RACADM
netstat
NOTE: To use this command, you must have Execute Diagnostic Commands
permission.
Table A-46 describes the netstat subcommand.
Synopsis
racadm netstat
Supported Interfaces
• Remote RACADM
• telnet/ssh RACADM
ping
NOTE: To use this command, you must have Execute Diagnostic Commands or
Configure iDRAC6 permission.
Table A-47 describes the ping subcommand.
Table A-46. netstat
Subcommand Definition
netstat Displays the routing table and the current connections.
Table A-47. ping
Subcommand Definition
ping Verifies that the destination IP address is reachable from iDRAC6
with the current routing-table contents. A destination IP address is
required. An ICMP echo packet is sent to the destination IP address
based on the current routing-table contents.