Dell IDRAC6 - Page 275

Using iDRAC6 Enterprise SM-CLP Command Line Interface 275
Table 16-2 describes the SM-CLP options. Some options have abbreviated
forms, as shown in the table.
Table 16-2. Supported SM-CLP Options
SM-CLP Option Description
-all, -a Instructs the verb to perform all possible functions.
-destination Specifies the location to store an image in the dump
command.
Syntax:
–destination <URI>
-display, -d Filters the command output.
Syntax:
-display <properties | targets | verbs>[,
<properties | targets | verbs>]*
-examine, -x Instructs the command processor to validate the command
syntax without executing the command.
-help, -h Displays help for the verb.
-level, -l Instructs the verb to operate on targets at additional levels
beneath the specified target.
Syntax:
-level <
n | all>
-output, -o Specifies the format for the output.
Syntax:
-output format=<text | clpcsv | keyword |
clpxml>
or
-o format=<text | clpcsv | keyword |
clpxml>
-source Specifies the location of an image in a load command.
Syntax:
–source <URI>
-version, -v Displays the SMASH–CLP version number.