Dell IDRAC6 - Page 354

354 RACADM Subcommand Overview
Synopsis
racadm getraclog -i
racadm getraclog [-A] [-o] [-c
count ] [-s start-
record
] [-m]
Description
The getraclog -i command displays the number of entries in iDRAC6 log.
NOTE: If no options are provided, the entire log is displayed.
The following options allow the getraclog command to read entries:
Output
The default output display shows the record number, time stamp, source, and
description. The timestamp begins at midnight, January 1 and increases until
the managed server boots. After the managed server boots, the managed
server’s system time is used for the timestamp.
Table A-18. getraclog
Command Definition
getraclog -i Displays the number of entries in iDRAC6 log.
getraclog Displays iDRAC6 log entries.
Table A-19. getraclog Subcommand Options
Option Description
-A Displays the output with no headers or labels.
-c Provides the maximum count of entries to be returned.
-m Displays one screen of information at a time and prompts the user to
continue (similar to the UNIX more command).
-o Displays the output in a single line.
-s Specifies the starting record used for the display.