EasyManua.ls Logo

Dell PowerConnect 5424

Dell PowerConnect 5424
444 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
104 Configuring System Information
Warning
— A system warning has occurred.
Notice
— The system is functioning properly, but system notice has occurred.
Informational
— Provides device information.
Debug
— Provides detailed information about the log. If a Debug error occurs, contact Customer
Tech Support.
Delete Server
— Deletes the currently selected server from the Available Servers
list, when selected.
Severity to Include
— Indicates the log severity level to be reported by the remote server. The possible
field values:
Emergency
— The highest warning level. If the device is down or not functioning properly, an
emergency log message is saved to the specified logging location.
Alert
— The second highest warning level. An alert log is saved if there is a serious device
malfunction, for example, all device features are down.
Critical
— The third highest warning level. A critical log is saved if a critical device malfunction occurs,
for example, two device ports are not functioning, while the rest of the device ports remain functional.
Error
— A device error has occurred, for example, if a single port is offline.
Warning
— The lowest level of a device warning. The device is functioning, but an operational
problem has occurred.
Notice
— Provides device information.
Informational
— Provides device information.
Debug
— Provides debugging messages.
The Remote Log Server Settings page also contains a severity list. The severity definitions are the same
as the severity definitions in the Global Log Parameters page.
When adding a Log Server, the following additional parameters are available:
Supported IP Format
— Specifies the IP format supported by the server. The possible values are:
IPv6
— IP version 6 is supported.
IPv4
— IP version 4 is supported.
IPv6 Address Type
— When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
Link Local
— A Link Local address that is non-routable and used for communication on the same
network only.
Global
— A globally unique IPv6 address; visible and reachable from different subnets.
Link Local Interface
— When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
VLAN1
— The IPv6 interface is configured on VLAN1.
ISATAP
— The IPv6 interface is configured on ISATAP tunnel.

Table of Contents

Other manuals for Dell PowerConnect 5424

Related product manuals