Dell PowerConnect 5424

208 Configuring System Information
• Basic Access Mode — Defines the access rights of the community. The possible field values are:
–
Read Only — The management access is restricted to read-only, for all MIBs except the
community table, for which there is no access.
–
Read Write — The management access is read-write, for all MIBs except the community table,
for which there is no access.
–
SNMP Admin — The management access is read-write for all MIBs, including the community
table.
Check View to create a new view, or select an existing view Name. A view defines the objects available to
the community.
• Advanced — Selects an advanced SNMP view.
•
Group Name — Name of previously defined groups. The group defines the objects available to the
community.
•
Remove — Removes a community, when selected.
When defining a new SNMP community, the following additional parameters are available:
• Supported IP Format — Specifies the IP format supported by the community. The possible values are:
–
IPv6 — IP version 6 is supported.
–
IPv4 — IP version 4 is supported.
•
IPv6 Address Type — When the community supports IPv6 (see previous parameter), this specifies the
type of static address supported. The possible values are:
–
Link Local — A Link Local address that is non-routable and used for communication on the same
network only.
–
Global — A globally unique IPv6 address; visible and reachable from different subnets.
•
Link Local Interface — When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1 — The IPv6 interface is configured on VLAN1.
–
ISATAP — The IPv6 interface is configured on ISATAP tunnel.