Dell PowerConnect 5424

Configuring System Information 209
Defining a New Community
1 Open the SNMP Community page.
2 Click Add .
The
Add SNMP Community page opens:
Figure 6-93. Add SNMP Community
3 Select one of the following:
–
SNMP Management Station — Defines an SNMP community for a specific management station.
(A value of 0.0.0.0 specifies all management stations.)
–
All — Defines an SNMP community for all management stations.
4 Define the remaining fields.
5 Click Apply Changes .
The new community is saved, and the device is updated.