Dell PowerConnect 5424

286 Configuring Device Information
• LAG Type — The port types that comprise the LAG.
•
Admin Status — Enables or disables traffic forwarding through the selected LAG.
•
Current LAG Status — Indicates if the LAG is currently operating.
•
Re-Activate Suspended LAG — Reactivates a suspended LAG.
•
Operational Status — Operational status of the LAG.
•
Admin Auto Negotiation — Enables or disables Auto Negotiation on the LAG. Auto-negotiation is a
protocol between two link partners that enables a LAG to advertise its transmission rate, duplex mode
and flow control (the flow control default is disabled) abilities to its partner.
•
Current Auto Negotiation — The currently configured Auto Negotiation setting.
•
Admin Speed — The speed at which the LAG is operating.
•
Current LAG Speed — The currently configured speed at which the LAG is operating.
•
Admin Advertisement — The speed that the LAG advertises. Options include Maximum Capacity,
10 MB Half-Duplex, 10 MB Full-Duplex, 100 MB Full-Duplex and 1000 MB Full-Duplex.
•
Current Advertisement — The port advertises its speed to its neighbor port to start the negotiation
process. The possible field values are those specified in teh
Admin Advertisement field.
•
Neighbor Advertisement — Indicates the neighboring port’s advertisement settings. The field values
are identical to the Admin Advertisement field values.
•
Admin Flow Control — Enables/disables flow control, or enables the auto negotiation of flow control
on the LAG.
•
Current Flow Control — The user-designated flow control setting.
•
PVE (Uplink) — A port can be defined as a Private VLAN Edge (PVE) port of an uplink port, so that
it will be isolated from other ports within the same VLAN.
Defining LAG Parameters
1 Open the LAG Configuration page.
2 Select a LAG in the LAG field.
3 Define the fields.
4 Click Apply Changes .
The LAG parameters are saved to the device.
Modifying LAG Parameters
1 Open the LAG Configuration page.
2 Select a LAG in the LAG field.
3 Modify the fields.
4 Click Apply Changes .
The LAG parameters are saved to the device.