900100001
The NVRAM in the indicated node experienced a single-bit error. The error was automatically corrected by ECC.
Administrator action
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
900100004
The PCIe lane width was not successfully negotiated.
Administrator action
Reboot the node. If the event clears and does not recur, no other action is required.
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
900100018
The NVRAM board failed to respond to an Identify Controller command.
Description
During periods of I/O inactivity, an Identify Controller command is issued to make sure that the NVRAM card is still healthy. If
the NVRAM card does not respond, the card might have failed and the system will force the node to reboot.
Administrator action
Reboot the node. If the event clears and does not recur, no other action is required.
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
900100019
A message was sent from the NVRAM card to the host node.
Description
These events are often related to correctable errors that do not require further attention.
Administrator action
Reboot the node. If the event clears and does not recur, no other action is required.
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
Hardware events
165
To Next Page
Loading...
Need help?
General