100010006
A drive logged an error or a change in the disk subsystem.
Administrator action
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
100010007
The serially-attached SCSI (SAS) PHY monitor detected an excessive bit error rate in the SAS cable traffic.
Description
One or more nodes report a Bit Rate Error (BER) event message.
Administrator action
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
100010008
The serially-attached SCSI (SAS) PHY monitor detected an excessive bit error rate and disabled traffic on the SAS cables.
Administrator action
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
100010009
Disk repair was initiated.
Administrator action
This message is informational. No action is required.
100010010
Disk repair is complete.
Description
OneFS has reprotected all of the data on the drive after a smartfail operation, and the drive has been removed from the group.
Software events
37
To Next Page
Loading...
Need help?
General