900100020
The NVRAM card is not responding and the node has been set to read-only.
Description
Connection between the NVRAM card and the node was lost. In some cases, restarting the node will reload the NVRAM driver
and restore the connection.
Administrator action
Reboot the node. If the event clears and does not recur, no other action is required.
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
900100021
The NVRAM card did not respond to an arm vault command and the node has been set to read-only.
Administrator action
Reboot the node. If the event clears and does not recur, no other action is required.
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
900100022
The NVRAM card did not respond to an NVRAM command and the node has been set to read-only.
Administrator action
Reboot the node. If the event clears and does not recur, no other action is required.
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
900100023
The NVRAM card firmware reported a correctable error.
Administrator action
Reboot the node. If the event clears and does not recur, no other action is required.
If the event persists, gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to
gather cluster logs, see Gathering cluster logs.
166
Hardware events
To Next Page
Loading...
Need help?
General