900160014
A hardware issue was detected with the I2C bus.
Description
The I2C bus is a controller or bus that carries information from various sensors (for fan speed, power supply voltage, and
temperature) in a node chassis.
It is not critical to address this issue immediately, but this event will continue to appear until the issue has been addressed. While
this event is active, the node will not report correct values for the temperature, fans, or power supply health on the node.
Troubleshooting is required to determine if a hardware component must be replaced.
The event message provides you with the chassis and node slot of the affected node.
Administrator action
Gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to gather cluster logs,
see Gathering cluster logs.
900160015
Drive interface board fault detected.
Description
A drive interface board fault is an indicator that a compute node has failed. The compute node must be replaced. The compute
node is not a customer-replaceable part.
The event message provides you with the chassis and node slot of the affected node.
Administrator action
Gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to gather cluster logs,
see Gathering cluster logs.
900160016
Midplane fault detected.
Description
A midplane fault is an indicator that a chassis has failed. The chassis must be replaced. The chassis is not a customer-
replaceable part.
The event message provides you with the affected chassis.
Administrator action
Gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to gather cluster logs,
see Gathering cluster logs.
188
Hardware events
To Next Page
Loading...
Need help?
General