Administrator action
Gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to gather cluster logs,
see Gathering cluster logs.
200020009
A power supply has failed in an internal network switch.
Description
The power supply is not a replaceable part. You will need to schedule a maintenance window to replace the switch.
The event message provides you with the switch serial number and the network fabric supported by the switch.
Administrator action
Gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to gather cluster logs,
see Gathering cluster logs.
200020010
An internal network switch has failed.
Description
You will need to schedule a maintenance window to replace the switch.
The event message provides you with the switch serial number and the network fabric supported by the switch.
Administrator action
Gather logs, and then contact Technical Support for additional troubleshooting. For instructions on how to gather cluster logs,
see Gathering cluster logs.
200020011
A 40-Gigabit Ethernet link is not operating at maximum throughput.
Administrator action
Determine whether the issue is related to the cable or the node. Perform the following steps in the order listed. If the issue
resolves after a step, there is no need to complete the subsequent steps.
1. Verify the following connections:
● All of the cables in the rack and in adjacent racks are connected securely to the node and neither the cable nor the
connector is damaged.
● The cable is rated for the appropriate Ethernet speed.
● The switch port speed is set to the same or higher speed as the Ethernet cable.
● The switch port is set to the Full Duplex setting.
60
Software events
To Next Page
Loading...
Need help?
General