Administrator action
Replace the drive by following the instructions in the drive replacement guide for your node type, which can be downloaded
from the Dell EMC Online Support site.
100010011
One or more failed drives in this node are ready to be replaced.
Administrator action
Review the messages that were generated during the most recent FlexProtect job in the /var/log/messages file.
● If the Flexprotect job completed successfully, replace the drive by following the instructions in the drive replacement guide
for your node type, which can be downloaded from the Dell EMC Online Support site.
● If the Flexprotect job failed, contact Dell EMC PowerScale Technical Support for additional troubleshooting.
100010012
The disk has stalled and the disk health is being evaluated.
Administrator action
This message is informational. No action is required.
100010013
There is an error in a disk sector.
Description
If enough disk errors occur, the drive is automatically smartfailed. If a disk smartfails and should be replaced, another event is
generated.
Administrator action
This message is informational. No action is required.
100010014
The disk ECC list is full.
Description
The ECC list contains information about disk sector errors. If sufficient errors are recorded for a particular disk, the drive can
become unusable and will be smartfailed by the system.
This event also might occur if the ECC list configuration has changed.
38
Software events
To Next Page
Loading...
Need help?
General