Also, if there are different instances of the same route-map, then it’s sufficient if a permit match happens
in any instance of that route-map.
Dell(conf)#route-map force permit 10
Dell(config-route-map)#match tag 1000
Dell(config-route-map)#match metric 2000
In the following example, instance 10 permits the route having a tag value of 1000 and instances 20 and
30 deny the route having a tag value of 1000. In this scenario, Dell Networking OS scans all the instances
of the route-map for any permit statement. If there is a match anywhere, the route is permitted.
However, other instances of the route-map deny it.
Example of the match Command to Permit and Deny Routes
Dell(conf)#route-map force permit 10
Dell(config-route-map)#match tag 1000
Dell(conf)#route-map force deny 20
Dell(config-route-map)#match tag 1000
Dell(conf)#route-map force deny 30
Dell(config-route-map)#match tag 1000
Configuring Match Routes
To configure match criterion for a route map, use the following commands.
• Match routes with the same AS-PATH numbers.
CONFIG-ROUTE-MAP mode
match as-path as-path-name
• Match routes with COMMUNITY list attributes in their path.
CONFIG-ROUTE-MAP mode
match community community-list-name [exact]
• Match routes whose next hop is a specific interface.
CONFIG-ROUTE-MAP mode
match interface interface
The parameters are:
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/
subport information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
– For a port channel interface, enter the keywords port-channel then a number.
– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• Match destination routes specified in a prefix list (IPv4).
CONFIG-ROUTE-MAP mode
match ip address prefix-list-name
• Match destination routes specified in a prefix list (IPv6).
CONFIG-ROUTE-MAP mode
102
Access Control Lists (ACLs)
To Next Page
Loading...
