Dell S6000–ON - Resetting an Interface to Its Factory Default State

no ip address
shutdown
!
interface TenGigabitEthernet 2/7/1
no ip address
shutdown
!
interface TenGigabitEthernet 2/8/1
no ip address
shutdown
!
interface TenGigabitEthernet 2/9/1
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the configurations applied on an interface to its factory default state. To reset the
configuration, perform the following steps:
1. View the configurations applied on an interface.
INTERFACE mode
show config
Dell(conf-if-te-1/5/1)#show config
!
interface TenGigabitEthernet 1/5/1
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2. Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type slot/port[/subport]
Dell(conf)#default interface tengigabitethernet 1/5/1
3. Verify the configuration.
INTERFACE mode
show config
Dell(conf-if-te-1/5/1)#show config
!
interface TenGigabitEthernet 1/5/1
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.
378
Interfaces