Dell S6000–ON - Viewing the LLDP Configuration

Figure 75. Configuring LLDP
Viewing the LLDP Configuration
To view the LLDP configuration, use the following command.
• Display the LLDP configuration.
CONFIGURATION or INTERFACE mode
show config
Examples of Viewing LLDP Configurations
The following example shows viewing an LLDP global configuration.
Dell(conf)#protocol lldp
Dell(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 10
no disable
Dell(conf-lldp)#
Dell(conf-lldp)#exit
Dell(conf)#interface tengigabitethernet 1/31/1
Dell(conf-if-te-1/31/1)#show config
!
interface TenGigabitEthernet 1/31/1
no ip address
switchport
no shutdown
Dell(conf-if-te-1/31/1)#protocol lldp
Dell(conf-if-te-1/31/1-lldp)#show config
!
protocol lldp
Dell(conf-if-te-1/31/1-lldp)#
538
Link Layer Discovery Protocol (LLDP)