EasyManua.ls Logo

Dell S6000–ON - Debugging VLAN Stacking

Dell S6000–ON
1080 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INTERFACE mode
portmode hybrid
2. Add the port to a 802.1Q VLAN as tagged or untagged.
INTERFACE VLAN mode
[tagged | untagged]
Example of Configuring a Trunk Port as a Hybrid Port and Adding it to Stacked VLANs
In the following example, TenGigabitEthernet 1/1/1 is a trunk port that is configured as a hybrid
port and then added to VLAN 100 as untagged VLAN 101 as tagged, and VLAN 103, which is a stacking
VLAN.
Dell(conf)#interface tenigabitethernet 1/1/1
Dell(conf-if-te-1/1/1)#portmode hybrid
Dell(conf-if-te-1/1/1)#switchport
Dell(conf-if-te-1/1/1)#vlan-stack trunk
Dell(conf-if-te-1/1/1)#show config
!
interface TenGigabitEthernet 1/1/1
no ip address
portmode hybrid
switchport
vlan-stack trunk
shutdown
Dell(conf-if-te-1/1/1)#interface vlan 100
Dell(conf-if-vl-100)#untagged tengigabitethernet 1/1/1
Dell(conf-if-vl-100)#interface vlan 101
Dell(conf-if-vl-101)#tagged tengigabitethernet 1/1/1
Dell(conf-if-vl-101)#interface vlan 103
Dell(conf-if-vl-103)#vlan-stack compatible
Dell(conf-if-vl-103-stack)#member tengigabitethernet 1/1/1
Dell(conf-if-vl-103-stack)#do show vlan
Codes: * - Default VLAN, G - GVRP VLANs
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description Q Ports
* 1 Inactive
100 Inactive U Te 1/1/1
101 Inactive T Te 1/1/1
103 Inactive M Te 1/1/1
Debugging VLAN Stacking
To debug VLAN stacking, use the following command.
Debug the internal state and membership of a VLAN and its ports.
debug member
Example of Debugging a VLAN and its Ports
The port notations are as follows:
MT — stacked trunk
MU — stacked access port
T — 802.1Q trunk port
816
Service Provider Bridging

Table of Contents

Other manuals for Dell S6000–ON

Related product manuals